asterixdb-dev mailing list archives

Site index · List index
Message view « Date » · « Thread »
Top « Date » · « Thread »
From Murtadha Hubail <>
Subject Re: debugging RecoveryIT
Date Fri, 06 Nov 2015 06:47:33 GMT
I think the easiest way without having to attach a remote debugger is to execute their queries
manually in the web interface after running AsterixHyracksIntegrationUtil in debugging mode.
When it is time to execute, just kill -9 the AsterixHyrackIntegrationUtil process.
Then run AsterixHyrackIntegrationUtil again and it will perform the recovery.


> On Nov 5, 2015, at 10:14 PM, Ildar Absalyamov <> wrote:
> Till,
> The only way I found to debug it sometime ago when I needed was to add remote debugger
into CC/NC JVM properties of asterix-configuration.xml (asterix-installer/src/main/resources/conf),
which is used to setup mini cluster to tests.
>> On Nov 6, 2015, at 11:07, Till Westmann <> wrote:
>> Hi,
>> I’m wondering how people go about running the code that is executed by one of the
RecoveryIT in the debugger.
>> I imagine that there are number of ways to do that.
>> If you have done this at some point, could you describe how you did that?
>> Thanks,
>> Till
> Best regards,
> Ildar

View raw message