manifoldcf-user mailing list archives

Site index · List index
Message view « Date » · « Thread »
Top « Date » · « Thread »
From Mark Libucha <mlibu...@gmail.com>
Subject Parameters question
Date Wed, 11 Dec 2013 23:48:38 GMT
Hi,

I'm writing an output connector and can't figure out how to get any
parameter values other than the default values to display in the webapp.

What is the flow from the agent? When I bring up my connector's tab in the
Edit Job page, only the output connector's connect() method is being called
into by the agent, but it's *passing* the config parameters, not asking for
them.

Where does the agent get them from to begin with? I want to be able to set
some of the parameters dynamically.

Hope that makes sense.

Thanks,

Mark

Mime
View raw message